These tables are calculated and not the result of experiment. They are published as a guide only and not as an authoritative document. The fusing currents have been calculated from basic physical properties (tinned copper) and may vary in practice with different positions, air circulation etc The fuse ratings are assumed to be half fusing current. The wire ratings are based on cable ratings of 8500A/sq in and in practice this max rating will depend on ambient temp, insulation, position and cable life expectancy. Cables can be run at higher currents and temperatures only if the insulation can stand it! This information is for experimental use only by careful and competent persons and in no circumstances should it be used for any other purpose.

No legal liability will be accepted for any consequences following from the use of this information.
Installations in buildings within the UK must follow the appropriate British Standard

AWG	SWG	Diameter	CSA	Fusing Current	Fuse Rating	Wire Rating
		mm	sq mm	Amps	Amps	Amps
32		0.202	0.032	7	4	0.4
	35	0.214	0.036	8	4	0.5
31	34	0.226	0.04	9	5	0.5
	33	0.250	0.049	10	5	0.6
30		0.255	0.051	10	6	0.7
	32	0.269	0.057	11	6	0.8
29	31	0.288	0.065	12	7	0.9
	30	0.315	0.078	14	7	1.0
28		0.321	0.081	15	8	1.1
	29	0.331	0.086	15	9	1.1
27		0.362	0.103	17	10	1.4
	28	0.397	0.124	20	10	1.6
26		0.404	0.128	21	10	1.7
	27	0.410	0.132	21	12	1.7
25	26	0.454	0.162	24	14	2.1
	25	0.496	0.193	28	15	2.5
24		0.517	0.21	30	17	2.8
	24	0.559	0.245	33	17	3.2
23		0.574	0.259	35	19	3.4
	23	0.613	0.295	38	21	3.9
22		0.642	0.324	41	25	4.3
	22	0.723	0.41	49	25	5.4
21		0.724	0.412	49	29	5.4
	21	0.807	0.511	58	31	6.7
20		0.841	0.556	62	34	7.3
19		0.900	0.636	68	35	8.4
	20	0.917	0.66	70	41	8.7
	19	1.017	0.813	82	42	10
18		1.026	0.826	83	49	11
17		1.151	1.04	99	54	14
	18	1.221	1.17	108	60	15
16		1.306	1.34	119	69